Edge Sealant Preservative Red 1Ltr

ESP Panels extends the life of panel products by creating a watertight seal around the edge of the boards, stopping moisture penetration to protect against delamination. Ideal for external use and high humidity areas. ESP is proven to make plywood last longer. The Plywood Sealant is applied to the bare edges (including freshly cut edges) of the plywood boards. A thick layer is painted down the edge with a 5mm overlap onto the flat surface. Ensure that any holes or air pockets are completed covered. This can be done by working the sealant along the edge, back and forth with a paint brush.

Ideal for:

•Plywood
•OSB
•MDF
•Sterling Board

Features:

•Easy Application
•Quick Drying
•Stabilizes plywood from warping
•Stops water ingress and delamination
•Reduces risk of mould and rot
•Proven to make plywood stronger

Coverage:

Panel Thickness 1 litre will seal Total cut edge
18 mm 21 sheets 183 metres
12 mm 32 sheets 234 metres
9 mm 37 sheets 270 metres

Panel Thickness 500ml will seal Total cut edge
18 mm 12 sheets 91 metres
12 mm 16 sheets 117 metres
9 mm 18 sheets 135 metres

Panel Thickness 125 ml will seal Total cut edge
18 mm 3 sheets 21 metres
12 mm 4 sheets 29 metres
9 mm 4.6 sheets 36 metres

Advice:

Ensure that all areas to be sealed are clean, free of dust, mud, and ‘muck’. If necessary, clean the surface thoroughly with clean water and allow to dry.
For optimum results ensure that the plywood is clean and dry before application.

A thick layer is painted down the edge with a 5mm overlap onto the flat surface (see insert). Ensure that any holes or air pockets are completed covered. This can be done by working the sealant along the edge, back and forth with a paint brush.
• For best results use a woodwork stain and varnish brush for an even finish.
• Can be applied by roller: recommended a minimum of a medium pile roller sleeve.

Drying Time:

Touch dry within 2 hours depending on drying conditions and humidity.